Thread: Bent push rod
View Single Post
  #5  
Old 06-17-2017, 10:55 AM
Longstroke Longstroke is offline
Senior Vegistroker
 
Join Date: Aug 2008
Location: East TN
Miles on Grease: 126,000
$ Estimated Saved: ??
MacGyver Rating: 5
Posts: 200
Default

From the engine assembly manual.

Rotate the engine until the mark on the crankshaft damper is at 11 o'clock, to prevent damage when installing the intake rocker arm and exhaust rocker arm.

1. Apply clean engine oil to the push rod, and insert the push rod, with the copper end up, into the engine. Make sure the push rod seats onto the lifter.
2. Position the rocker arm onto the cylinder head.
3. Install the bolts to 20 lb/ft.

Hope this helps.
BTW I'm guessing it was the exhaust valve push rod that bent correct.
__________________
95 F250XL PSD SuperCab BTS auto , Gearhead Tuned, Vegistroke V3 , Tymar Intake, Stage 1's ADRENALINE HPOP. Absolute CF
Early 99 XLT SuperCab Auto, MBRP 4" Exhaust, DIY Tymar, Autometer Gauges.

Last edited by Longstroke; 06-17-2017 at 11:02 AM.
Reply With Quote