BioFuels Technologies Forum  

Go Back   BioFuels Technologies Forum > Members List

Puresoul108 Puresoul108 is offline

Senior goofball

Visitor Messages

Showing Visitor Messages 1 to 3 of 3
  1. AKJerry
    04-10-2016 01:36 AM
    If you are still trying to sell van....where is it located?
  2. Judge
    06-04-2014 02:34 PM
    I saw in the Tech write up on cleaning the purge valve and check valve that you may have knowledge of/where to get the sizes of the O-rings and plastic rings. I also read about the washer in the purge valve. I was very careful when I took mine apart and was surprised when I could not find it. I used dental tools to make sure it was not stuck in there still and I am confident it isn't in there? If you know the specs on that too it would be great.

    Thank You,

  3. justjamesjust
    06-22-2011 04:23 AM
    Hello, Hello Puresoul,
    I'm new to this forum, though I've been lurking on and off for about a year and a half. I just recently posted my introductory thread, so I have some basic questions there and skyskijason referred me to you.
    I have a 2001 e-350 superduty that's the long back-window-less one, right?
    anywho, 7.3 as you well know, and I too am looking at CF'ing whilst mobile.
    I was also told by someone at BFT that the wiring diagram for the e's are different than the one that come in the standard install guide and that you had figured it all out.
    I guess I just wanted to start a dialog, it seems everyone's doing F's but for mobile travel e's are awesome. I've scoured the forums and there's very little E specific info. Any help would be so very greatly appreciated.
    I'll keep this first message short and not get into to many specifics, don't want to overload you with questions, but anything you can think of that really sticks out or applies to my intro thread would be great.
    thanks again, james

About Me

  • About Puresoul108
    Miles On Grease
    $ estimated saved
    a whole lot!!!
  • Signature
    2000 E-350 7.3, cooling mist Water injection 150psi pump & one 250cc injector nozzle, Smith bros chromoly pushrods, Swamps single-shot injectors, about 270,000+ miles on SVO so far...


Total Posts
Visitor Messages
General Information
  • Join Date: 08-23-2010
  • Referrals: 0

All times are GMT. The time now is 04:44 PM.

Powered by vBulletin® Version 3.7.2
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.